View single post by max
 Posted: Tue Jan 13th, 2009 09:05 am
PM Quote Reply Full Topic
max



Joined: Fri Dec 28th, 2007
Location: Too Far South, Florida, USA
Posts: 551
Status: 
Offline
 Guess Ill throw my 2 cents in.

I start at the 6 position and take out links till the clasp sits where I want it to on my wrist.  Taking out an even number of links on each side doesnt always work especially so if you have small wrists.

If you do have collars, make sure the push pin on your sizing tool is small enough to go through them.  Some arent.

I put scotch tape on the sides of the bracelet and push the pin through this so if it slips there is no scratching.  I put it on the lugs changing straps also.  Keeps the tool from scratching the inside of the lugs.