oagaspar
| Joined: | Sun Sep 4th, 2005 |
| Location: | Akron, USA |
| Posts: | 28866 |
| Status: |
Offline
|
|
Go on e-bay and search bracelet/deployant strap extensions....they make an extender for this reason hand6.gif The cost of the signed links/buckle end and then cut them would probably run as much as a bracelet imo...I will ask Enzo as it is his bracelet:) I measured my links and at the clasp the 2 are 11mm and the regular links are 8mm....so all he actually needed was 1mm for his to fit perfect....I think I could live w/mine being 1mm loose:D I think it would be easier to design and make or just find a elongated flat washer 5mm wide by 2mm long same as the link thickness that would attach between the links using the original link screws to hold them in place and extend the bracelet it would be far less expensive/noticeable than cutting a link to give an extra 1mm imho...or just make a real half link!
|
