View single post by oagaspar
 Posted: Thu Dec 13th, 2007 06:08 pm
PM Quote Reply Full Topic
oagaspar



Joined: Sun Sep 4th, 2005
Location: Akron, USA
Posts: 28506
Status: 
Offline
 The Burgeon bezel tool runs $359. at Ofrei and it is the best imho but you may not want to spend that ...there are some for less but not by much:D...you could remove it with a case tool which is around $20. and under or even a screwdiver by getting it under and between the case and bezel and pop it off but if you haven't done it before you may want to practice on a cheapie and make sure you tape off the case good to avoid gouging it...but I wouldn't reccomend it unless you have practiced and even then I would use cation on a watch that cost as much as the Divemaster....some pop off easily others don't...snapping them back on is the same....

     most WIS change out the bezel inlays to other colors but in your case that bezel has no inlay;) You will also have to make sure the aftermarket bezel is an exact fit....do a search on this forum as I believe one of our 3T advisers E.Avery/Eric may have posted a how-to...there are many tutorials on line if you just google "removing a watch bezel" that will help....Good Luck !!!....If all else fails send it out to one of the modders who would do it for way less and no risk to you.!hand6.gif

http://www.ofrei.com/page433.html